DATE
Thermostat calendar date COS: C13
Permissions: Read/Write
Query
Command
Syntax: SN[#] DATE?<CR>
Description: Requests the current calendar date held by the thermostat.
Assignment
Command
Syntax: SN[#] DATE=[mm][dd][yy]<CR>
Description: Sets the time to [mm] month, [dd] day and [yy] year.
Example: SN1 DATE=010110<CR>
Response or
COS Message
Syntax: SN[#] DATE=[mm][dd][yy]<CR>
Example: SN1 DATE=120110<CR>
Node address 1 responds with a date of December 1, 2010.
Parameters Range
mm: calendar month [01 – 12]
dd: calendar day [01 – 31]
yy: calendar year [00 – 99]
Month, day and year values less than 10 must be prepended with a leading 0. If the date is changed at the thermostat, a C13 COS unsolicited
message is issued (if C13 is ON).
PROGFMT
Thermostat program format COS: C13
Permissions: Read/Write
Query
Command
Syntax: SN[#] PROGFMT?<CR>
Description: Requests the program format setting.
Assignment
Command
Syntax: SN[#] PROGFMT=[value]<CR>
Description: Sets the program format setting to [value].
Example: SN1 PROGFMT=2<CR>
Response or
COS Message
Syntax: SN[#] PROGFMT=[value]<CR>
Example: SN1 PROGFMT=2<CR>
Node address 1 responds with a program format of 7-day.
Parameters Range
value: program format code [0 – 3]
0: 5/2 program (Weekdays and Weekends)
1: 5/1/1 program (Weekdays, Saturday and Sunday)
2: 7-day program (Mon, Tue, Wed, Thu, Fri, Sat, Sun)
3: non-programmable
If the program format is changed at the thermostat, a C13 COS unsolicited message is issued (if C13 is ON).
21
To Next Page
Loading...
