EVTCFG
Thermostat program event configuration COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] EVTCFG?<CR>
Description: Requests the program event configuration setting.
Assignment
Command
Syntax: SN[#] EVTCFG=[value]<CR>
Description: Sets the program event configuration setting to [value].
Example: SN1 EVTCFG=RES<CR>
Response Syntax: SN[#] EVTCFG=[value]<CR>
Example: SN1 EVTCFG=RES<CR>
Node address 1 responds with an event configuration setting of residential.
Parameters Range
value: program format code [RES, COM]
RES: residential event labels
COM: commercial event labels
If the program event configuration is set to commercial, the events per day setting is automatically set to 2 events per day.
This command is ignored if the controller type is set to humidistat.
EVTSDAY
Thermostat program events per day COS: C13
Permissions: Read/Write
Query
Command
Syntax: SN[#] EVTSDAY?<CR>
Description: Requests the program events per day setting.
Assignment
Command
Syntax: SN[#] EVTSDAY=[value]<CR>
Description: Sets the program events per day setting to [value] events per day.
Example: SN1 EVTSDAY=4<CR>
Response or
COS Message
Syntax: SN[#] EVTSDAY=[value]<CR>
Example: SN1 EVTSDAY=4<CR>
Node address 1 responds with an events per day setting of 4.
Parameters Range
value: program events per day [2, 4]
4: four events per day
2: two events per day
If the EVTCFG setting is set to commercial, the EVTSDAY setting is fixed at 2.
This command is ignored if the controller type is set to humidistat. If the program events per day setting is changed at the thermostat, a C13
COS unsolicited message is issued (if C13 is ON).
22
To Next Page
Loading...
