DLS
Daylight savings time setting COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] DST?<CR>
Description: Requests the daylight savings time setting.
Assignment
Command
Syntax: SN[#] DST=[value]<CR>
Description: Sets the daylight savings time setting to [value].
Example: SN1 DST=MARCH<CR>
Response Syntax: SN[#] DST=[value]<CR>
Example: SN1 DST=MARCH<CR>
Node address 1 responds with a daylight savings time setting of March to November.
Parameters Range
value: daylight savings setting code [OFF, MARCH, APRIL]
OFF: daylight savings time is disabled
MARCH: daylight savings time starts in March and ends in November
APRIL: daylight savings time starts in April and ends in October
BLTLVL
Backlight intensity level COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] BLTLVL?<CR>
Description: Requests the backlight intensity level setting.
Assignment
Command
Syntax: SN[#] BLTLVL=[value]<CR>
Description: Sets the backlight level to [value].
Example: SN1 BLTLVL=100<CR>
Response Syntax: SN[#] BLTLVL=[value]<CR>
Example: SN1 BLTLVL=90<CR>
Node address 1 responds with a backlight intensity level of 90.
Parameters Range
value: backlight level in steps of 10 [0 – 100]
Default: 100
23
To Next Page
Loading...
