CONSTBLT
Constant backlight setting COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] CONSTBLT?<CR>
Description: Requests the constant backlight setting.
Assignment
Command
Syntax: SN[#] CONSTBLT=[value]<CR>
Description: Sets the constant backlight setting [value].
Example: SN1 CONSTBLT=OFF<CR>
Response Syntax: SN[#] CONSTBLT=[value]<CR>
Example: SN1 CONSTBLT=OFF<CR>
Node address 1 responds with a constant backlight setting of OFF.
Parameters Range
value: constant backlight setting [OFF, ON]
OFF: disabled
ON: enabled
BLTON
Backlight activation COS: N/A
Permissions: Write only
Assignment
Command
Syntax: SN[#] BLTON<CR>
Description: Turns on the backlight.
Example: SN1 BLTON<CR>
Response Syntax: SN[#] BLTON<CR>
Example: SN1 BLTON<CR>
Node address 1 responds with backlight on.
When this command is issued by the Host, the node activates the backlight for 10 seconds. NOTE: The assignment command has no parameters.
24
To Next Page
Loading...
