Aprilaire 8800 - Page 28

NETLK
User network override feature configuration COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] NETLK?<CR>
Description: Requests the network override feature setting.
Assignment
Command
Syntax: SN[#] NETLK=[value]<CR>
Description: Sets the network override feature setting to [value].
Example: SN1 NETLK=0<CR>
Response Syntax: SN[#] NETLK=[value]<CR>
Example: SN1 NETLK=0<CR>
Node address 1 responds with a network override feature setting of enabled.
Parameters Range
value: network override feature setting code [0 – 1]
0: enabled
1: disabled
UPDNLK
User setpoint lockout configuration COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] UPDNLK?<CR>
Description: Requests the setpoint lockout configuration setting.
Assignment
Command
Syntax: SN[#] UPDNLK=[value]<CR>
Description: Sets the mode setpoint configuration setting to [value].
Example: SN1 UPDNLK=0<CR>
Response Syntax: SN[#] UPDNLK=[value]<CR>
Example: SN1 UPDNLK=0<CR>
Node address 1 responds with a setpoint lockout setting of disabled.
Parameters Range
value: setpoint lockout setting code [0 – 4]
0: lockout disabled
1: time-limited lockout; changes within normal setpoint range allowed
2: time-limited lockout; changes within limited setpoint range allowed
3: lockout enabled; no changes allowed
4: changes within limited setpoint range allowed
The five setpoint lockout settings provide varying degrees of setpoint lockout. Time-limited lockouts must be enabled in conjunction with the
temporary change period (LKTIME command). Range-limited lockouts must be enabled in conjunction with the setpoint lockout limit (LKLIMIT).
28