PERMHOLD
Permanent hold COS: N/A
Permissions: Read/Write
Query
Command
Syntax: SN[#] PERMHOLD?<CR>
Description: Requests the state of the thermostat program permanent hold.
Assignment
Command
Syntax: SN[#] PERMHOLD=[value]<CR>
Description: Sets the permanent hold state to [value].
Example: SN1 PERMHOLD=OFF<CR>
Response Syntax: SN[#] PERMHOLD=[value]%<CR>
Example: SN1 PERMHOLD=ON<CR>
Node address 1 responds with a permanent hold state of ON.
Parameters Range
value: permanent hold state [OFF, ON]
If an assignment command is received with the value parameter set to ON and another hold type is currently active, the currently active hold
is replaced by the permanent hold. An assignment command with value parameter set to OFF cancels an active permanent hold. The current
hold status can be read using the HOLDSTAT command. A permanent hold can also be cancelled using the HOLDSTAT command.
This command is ignored if the controller type is set to humidistat or if the thermostat is configured as non-programmable. The permanent
hold state can be changed through the Home Screens for thermostat control. If the permanent hold state is changed at the thermostat, a C17
COS unsolicited message is issued (if C17 is ON).
49
To Next Page
Loading...
