COPYDx
Copy from day x COS: N/A
Permissions: Write only
Assignment
Command
Syntax: SN[#] COPYD[x]=[copy_to]<CR>
Description: Copies all events of day [x] to day [copy_to].
Example: SN1 COPYD1=2<CR>
Response Syntax: SN[#] COPYD[x]=[copy_to]<CR>
Example: SN1 COPYD7=8<CR>
Node address 1 responds with copying all events from Weekdays to Weekends.
Parameters Range
x: day of the week to copy from [0 – 8]
copy_to: day to copy to [0 – 9]
0: Monday
1: Tuesday
2: Wednesday
3: Thursday
4: Friday
5: Saturday
6: Sunday
7: Weekdays
8: Weekends
9: Everyday (copy_to only)
Thermostat event programming can be copied from day one day to another day or set of days using this command.
If an assignment command is received with a day of the week code [copy_to] parameter of 7-9, each day corresponding to the day of
the week code [copy_to] is configured with the events of the [x] day (assuming correct syntax, etc.).
This command is ignored if the controller type is set to humidistat or if the thermostat is configured as non-programmable. In addition,
commands with a day of the week code in conflict with the program format are ignored. (E.g. if the thermostat is configured with a program
format of 5/2 and a day of the week code of 0-6 is received, the command is ignored since the thermostat cannot program days individually in
the 5/2 program format.)
48
To Next Page
Loading...
