Aqualisa QUARTZ BLUE - Wi-Fi Network Connection; Selecting the Wi-Fi Network; Successful Connection Confirmation; Connection Troubleshooting

Set up Shower - Wi-Fi
The Aqualisa app will direct you to the Wi-Fi settings
menu on your mobile device.
From the list of available Networks select: QSVC XXXX
The password is: SmartShower
N.B. Depending on Wi-Fi signal strength, the
connection may take a few minutes. Follow the
instructions on the Aqualisa app. Upon completion of
this, continue with the below.
The LEDs will flash slowly to indicate the Aqualisa
SmartValve
TM
is connecting to the Aqualisa app
and will switch to being solid green, indicating a
successful connection.
A successful connection message will provide
confirmation in the Aqualisa app journey and the LEDs
on the controller will turn o to indicate that the
shower is ready for use.
If connection is unsuccessful a message will appear in
your Aqualisa app. Redo the steps above or refer to
app troubleshooting at www.aqualisa.co.uk/smartapp.
If the timer setting is adjusted within the Aqualisa app, then the shower
will run for the newly set duration, overriding the default maximum run
time. N.B. The water flow will stop at the end of the timer.
The Aqualisa app gives you the capability to operate your product
remotely using your mobile device. It is the responsibility of the user
to ensure that it is safe to remotely activate the water flow. Aqualisa
recommend that baths and showers in operation are not left unattended.
Cleaning tip: To keep your shower eortlessly clean, we recommend
drying all shower components with a soft cloth after use.
Caring for your Shower
Over time, your shower may be aected by hard water scaling. To keep your shower
working eectively, we recommend that you clean your shower regularly.
Your product should be cleaned using only a soft cloth and washing up liquid. The
bath system ‘click clack’ waste plug mechanism (if applicable) should be kept clear of
debris to ensure the plug maintains a watertight seal. The plug can be unscrewed and
removed to check and clean the mechanism.
Cleaning the shower head
To reduce the need for chemical descaling in hard water areas, your shower head
incorporates a ‘clear flow’ system, whereby any scale build up can be broken down
by gently rubbing the flexible tips of the jets during use. This procedure should be
completed regularly, as often as once a week in some hard water areas, as scale build
up can aect the spray pattern and cause the shower to perform poorly. Failure to
descale the shower head can aect the internal seals and may aect the warranty.
Should descaling of the head using a cleaning agent become necessary, remove the
shower head fully and immerse in a mild proprietary descaler (e.g. vegetable based or
plain white vinegar). Cleaning and maintenance should not be undertaken by children
without supervision by a person responsible for their safety.
DO NOT USE ABRASIVE CLEANERS. It is imperative that descaling
is carried out in accordance with the manufacturer’s instructions,
substances that are not suitable for plastics and electroplated surfaces
must not be used.
Changing water system?
If switching from a gravity-fed water system to a mains pressure system (e.g.
Combination boiler) you will need to change your Aqualisa SmartValve
TM
. Contact a
member of our Customer Service team for further information.
10 11