28/02/2020 Page 18 of 41 ARB Copyright 2018 3789452
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.14) Pull the rest of the canopy vehicle patch harness
through into the LH rear passenger foot well area.
3.15) Release the lower portion of the “C” pillar trim at
the rear of the LH rear door.
3.16) Remove the Xmas tree clip holding the floor
carpet down under the rear seat.
3.17) Slide the 6 pin black/yellow connector from the
patch harness into the sheetmetal hole under the
floor carpet, aiming it towards the storage
compartment under the seat.
To Next Page
Loading...
