If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.36) Connect the blade terminal yellow and black wire
from the brake light patch loom into the free
position at the back of the connector from the
main canopy patch harness under the LH rear
corner of the cabin.
Refit all scuff plates, kick panels, interior trim
panels and Xmas tree clips previously
removed after clipping in the wiring harness
along the clips under the scuff plates in the
door areas.
To Next Page
Loading...
