28/02/2020 Page 5 of 41 ARB Copyright 2018 3789452
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
SECTION 1: PREPARING THE VEHICLE TUB – REMOVAL OF SPORTS BARS & CABIN GUARDS.
1.1) Remove any sports bars or cabin guards fitted on the front bed rail of the vehicle’s tub.
1.2) Bed liners fitted to the vehicle should also be removed and hardware retained for refitting.
SECTION 2: FITTING THE CANOPY TUB MOUNTING BRACKET SYSTEM AND TUB SEALING.
2.0) Clean the front tub rail at the back of the vehicle’s
cabin with Isopropyl Alcohol (Use the wipes
provided 6602018) and a lint free rag.
Apply black stickers (668PB006) over the 2 open
holes in the top of the front tub panel as shown, to
provide a water seal.
2.1) Starting from the inside edge of the side tub rails,
apply soft foam tape (668PB018) along the top face
of the front of the vehicle’s tub. Align this to the
centre of the top face. Trim tape level to butt up to
the inside of the side tub rail on the opposite side.
To Next Page
Loading...
