28/02/2020 Page 8 of 41 ARB Copyright 2018 3789452
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
2.9) Bolt the front corner brackets (668PD061L shown)
to the lower tie down hook mounting points in the
tub. Insert 2 off M8x25mm Torx bolts (6151625)
through the retained tie down hook and through the
bracket into the tub mounting points. Ensure the
top bracket tags engage to top of the sides of the
vehicle tub and push the bracket forwards to meet
up to the front head board rail bracket. Do bolts up
to 22Nm.
2.10) Clamp the front corner bracket (LH shown) to
the side of the vehicle’s inner tub lip channel in the
front corner. Ensure the bracket is pushed down
so the bumpons on the underside of the bracket
engage to top of the side vehicle tub rails. Drill a
6.5mm hole through the exiting hole in the bracket
rear corner that rests against the side tub wall with
a 12mm deep drill stop fitted. Remove any swarf.
Apply rust inhibitor (665505) to the drilled hole.
Repeat on other side of tub for the opposite
bracket.
To Next Page
Loading...
