1-10-2018 Page 44 of 54 ARB Copyright 2018 3789194
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
5.8) Measure the trim edges of the canopy at the rear
sides and at the front both sides, to the vehicle’s
tub and make this measurement even on both
sides of the canopy.
Look in the interior and ensure the mounting holes
in the steel mount rails on the canopy align to
holes in front tub corner mounting brackets and
the rear corner tub mounting brackets on both
sides of the vehicle.
5.9) Stand back and walk around the canopy and
check uniform balanced fit to the tub and cabin.
The canopy is central on the Ute body.
Alignment between cab and canopy is even both
sides
The rear door seals against the tailgate just and
evenly both sides without excessive force on
glass to close.
The gap is even between the door and frame
both sides.
5.10) Drop the canopy harness loom down between the
cabin and the tub on the LH side.
5.11) Connect the canopy wiring connector to the white
connector of the canopy wiring harness 668PJ012,
at the wheel arch area on top of the LH chassis
rail.
5.12) Go to the door and press the door push button
pad. Check the door opens and the actuator
functions to unlock the canopy door
5.13) Turn the interior light to the position that the interior
light turns off when the door is closed.
5.14) Press the key fob of the car to the unlock
position.
To Next Page
Loading...
