1-10-2018 Page 34 of 54 ARB Copyright 2018 3789194
If you have any queries regarding the installation of this product please contact the distributor from whom it was purchased, or alternatively the ARB office in your state.
Head Office – ARB Corporation Ltd VIC: 42-44 Garden Street, Kilsyth, Victoria, 3137 Tel: (03) 9761 6622 Fax: (03) 9761 6807
WA:(08) 9244 3553 NSW: (02) 9821 3633 ACT: (02) 6280 7475 SA: (08) 8244 5001 QLD: (07) 3872 3872 NT: (08) 8947 2262 TAS: (03) 6331 4190
3.47) Tighten all remaining Torx head M8 screws on tie
down brackets to 22Nm.
3.48) Tighten rear the two M6 screws securing Sport
Guard rear pillars in place to 9Nm.
3.49) The sport guard fitting with canopy mounting
brackets is now completed.
SECTION 4: FITTING THE VEHICLE WIRING
4.1) Remove 9 scrivets holding the LH wheel arch liner
on the vehicle tub, and remove the wheel arch
liner.
4.2) Add a piece of 13mm diameter split convoluted
tube cut 1600mm long (not supplied) to the battery
eyelet end of the canopy wiring loom in the
hardware kit (668PJ012).
To Next Page
Loading...
