Arbiter Systems 1093B - Page 211

INDEX 193
event input, 9
power inlet, 8
relay contacts, 10
serial communications, 9
timing output, 10
contact information, ii
copyright, v
cordsets
IED-320 power inlet connector, 11
crimp tool
RG-11, 20
digital drivers, 52
display
startup, 28
display modes
Position, 32
Time, 31
drive current vs. output voltage, 53
driver
analog, 52
digital, 52
elevation display, 32
event display indication, 30
event trapping, 64
arming, 64
fault indication
serial port, 72
fault modes, 30
firmware
updates, ii
front panel drawing, see panel drawing, front
fuses
replacing, 13
types and location, 13
handling
precautions, 1
IEC-320 power inlet connector, 8
initial clock time, 28
initial LED indication, 27
initial startup sequence, 27
inlet power, 11
IRIG-B
IEEE 1344 description, 54
initial indication, 30
modulated
voltage matching, 58
timecode description, 53, 54
unmodulated, 54
waveform comparison, 54
year information, 54
issuance, ii
jumpers
function selection, 25
JMP1 – output signal select, 23
JMP2 – output signal select, 23
JMP3 – output signal type, 23
JMP4 – output signal type, 23
JMP5 – data backup battery, 23
JMP6 – RS-232 Aux Output, 23
JMP7 – event selection, 23
locations, 23
shown on main board, 23
keys
description, 7
Down, 7
Enter, 8
Event/Deviation, 7
Position, 7
Setup, 7
Status, 7
Time, 7
Up, 7
latitude display, 32
LCD
display, 7
LED
status indicators, 6
longitude display, 32
mounting kit
antenna, 15
multiple devices
driving from one IRIG-B output, 56
NTP Server, 133
NTP/PTP Server, 140
numeric data entry mode, 35