EN
EN-11
In order to use the AirPlay and Chromecast built-in
functionality of the ST60, you will need to connect it to
your home network via a wireless or wired connection.
The following sections detail how to do this.
NOTE: Before attempting to setup a wireless
connection ensure the supplied wireless antennas are
tted to the antenna sockets on the rear of the ST60
NOTE: When the wired connection is used the wireless
connection is automatically disabled.
NOTE: The use of a screened ethernet cable is strongly
recommended.
AirPlay Setup
Wired Connection
Power up and connect an ethernet cable to the ST60.
To listen to audio via AirPlay on your ST60, ensure your
Apple device is connected to the same network as the
ST60 and simply select the ST60 as the AirPlay audio
playback device.
Note: By default the ST60 will appear as ST60-xxxxxx
in the AirPlay speaker menu, where xxxxxx is the last
6 digits of the units wired MAC address.
Wireless Connection
Ensure your Apple device is connected to the wireless
network you wish to connect the ST60 to.
Install the Wi-Fi antennas and power up the ST60
Open the Wi-Fi settings menu on the Apple device and
select the ST60 from the “Set up new AirPlay speaker”
menu.
Follow the instructions on screen.
To listen to audio via AirPlay on your ST60, ensure your
Apple device is connected to the same network as the
ST60 and simply select the ST60 as the AirPlay audio
playback device.
Note: By default the ST60 will appear as ST60-xxxxxx in
the AirPlay speaker setup menu, where xxxxxx is the last
6 digits of the unit’s wired MAC address.
Connecting to a Network
Chromecast built-in Setup
Wired Connection
Power up and connect an ethernet cable to the ST60.
Select the NET input.
Download and open the Google Home application.
Google Home
You should be prompted that there is a device available
for setup. If not, simply tap “Add” followed by “Setup a
Device”.
Select the ST60 and follow the instructions on screen.
To cast audio from any supported application on your
ST60, ensure your device is connected to the same
network as the ST60. Tap the Chromecast built-in icon
from within the application and select the ST60 as the
playback device.
Note: By default the ST60 will appear as ST60-xxxxxx,
where xxxxxx is the last 6 digits of the unit’s wired MAC
address.
Wireless Connection
Install the Wi-Fi antennas and power up the ST60.
Select the NETinput.
Download and open the Google Home application.
Google Home
You should be prompted that there is a device available
for setup. If not, simply tap “Add” followed by “Setup a
Device”.
Select the ST60 and follow the instructions on screen.
To cast audio from any supported application on your
ST60, ensure your device is connected to the same
network as the ST60. Tap the Chromecast built-in icon
from within the application and select the ST60 as the
playback device.
Note: By default the ST60 will appear as ST60-xxxxxx,
where xxxxxx is the last 6 digits of the unit’s wired MAC
address.
To Next Page
Loading...
