61
DIVISION II - OPERATION/
MAINTENANCE
Previous Main TOC Section TOC Next
GZ461A
Windshield (Cruiser)
To remove the windshield, loosen the left
and right plastic knobs and remove the
windshield assembly. Tighten the knobs
securely or remove them completely to
prevent loss.
CR003
To install the windshield, loosen the left
and right plastic knobs; then install the
tapered windshield pins into the mounts
and tighten knobs securely.
Mirrors (Cruiser)
The mirrors can be adjusted to the
desired viewing angle or moved to a
stowed position when operating in trees
or brush.
Rear Seat Lock
1. To remove the rear seat, pull the two
latch handles to the rear and rotate
them to the vertical position.
CR017D
2. Lift the rear of the seat up; then pull
slightly to the rear and lift the seat
off the mountings.
3. To lock the seat into position,
engage the two front mounting lugs
into the mounting rack; then, hold-
ing down firmly on the front of the
seat, push the seat forward until the
rear tabs engage the rear mounting
latches.
4. Lock the seat into position by rotat-
ing the latch handles to the horizon-
tal position; then push the handles
forward to lock.
CR017E
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
within the operating range.
CAUTION
Remove the windshield before traile-
ring the ATV or damage to the wind-
shield may occur.
! WARNING
Always adjust the mirrors to a posi-
tion that will not catch tree branches
or under-brush which could cause a
loss of control and severe injury or
death.
To Next Page
Loading...
