Argo CLIMIA CMK 4000 WiFi User Manual

04 - PRODUCT IDENTIFICATION
Room air conditioner with remote condenser CMK 4000
3
05 - MONITOR PANEL
Denition of the LED lamps:
Timer = YELLOW
Operation = GREEN
Standby = RED
11. Infrared rays remote control unit
12. Monitor panel
13. Supply air deector
14. Return air grille
15. Outdoor unit
16. Flexible tube
17. Air lter
18. Power cable with plug (about 2.30 m)
19. Service tube for condensate evacuation
10. Quick coupling cover
2
7
10
5
6
1
8
3
4
9
S
1
M
W
T
T
F
S
A
U
T
O
W
EEK
SE
T
2
3
A
1
2
43
5
6
1. Time setting lamp (TIMER): This lamp lights up when a timer is activated (see section “TIMER SELECTION”).
2. OPERATION lamp: This lamp lights up when you switch on the unit.
3. STANDBY lamp: This lamp lights up when the air conditioner is connected to the power and ready to receive the remote
control command.
4. Receiver: It receives signals transmitted from the remote control.
5. Operation button (without remote control): Push the button to switch on or o the unit (see section “OPERATION WITHOUT
REMOTE CONTROL UNIT”). Press and hold this button for 5 seconds to enable the WiFi conguration (Only for WiFi models, see
“WiFi INSTRUCTIONS” manual).
The OFF position does not disconnect the power. Use the main power switch to turn o power completely.
NOTE
WARNING
Please note that the color representation of the control panel on the device may vary and that the representation in these
operating instructions may dier. However, this does not aect the functionality and is purely optical in nature.
NOTE
Only if an error message is displayed, it may be necessary to carefully unplug the indoor unit to drain excess water. In other
cases, the plug should not be removed.

Argo CLIMIA CMK 4000 WiFi Specifications

General

Brand	Argo
Model	CLIMIA CMK 4000 WiFi
Category	Air Conditioner
Language	English