Argo CLIMIA CMK 4000 WiFi User Manual

Room air conditioner with remote condenser CMK 4000
7
09 - REMOTE CONTROL UNIT
HOW TO SET THE CLOCK
1. Turn on the unit with the ON / OFF
button.
2. Press the button until the
COOLING symbol appears on
the display.
3. Press the buttons to set the
desired temperature (
the temperature
range is between 10 ˚C and 32 ˚C
).
COOLING / AUTOMATIC MODE
NOTES
SET
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE
AND THE WORD “SET”.
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE
SETTING THE DISPLAY
WILL SHOW THE ROOM
TEMPERATURE AGAIN.
4. Press the button to select the fan speed.
1
If the fan is set in automatic mode and the unit stops
because setpoint is reached, also the fan will stop.
If the fan is set in one of the six manual speeds, it will
go on operating at the selected speed, even if the unit
stops due to reaching the setpoint.
When the external or internal temperature is too low,
the unit could limit the speed of the compressor or
formation of ice on the internal heat exchanger.
S
M
WT
T
F
S
AUTO
WEEK
SET
3
4
2.
3.
button to exit the clock menu.
1. Press for a few seconds the Timer button
Press the button
S
M
W
T
T
F
S
WEEK
SET
S
M
W
T
T
F
S
WEEK
ARROWS
2
DEHUMIDIFYING MODE (DRY)
ADJUSTING THE FAN SPEED
1. Turn on the unit with the ON / OFF button
2. Press the button until the DEHUMIDIFYING symbol
appears on the display .
3. Press the buttons to set the desired temperature
(
the temperature range is between 10 ˚C and 32 ˚C
).
• Use DRY operation when you want to reduce the
humidity in the room.
•
Once the room temperature reaches the set level, the
• During DRY operation, the fan speed is automatically
set (Remote control lamp is ON) to maximize
•
Dry operation is not possible if the indoor temperature
is less than 10 ˚C.
NOTES
If you want to make air circulate without any temperature
control, press the button until the FAN symbol
appears on the display .
FAN ONLY MODE
In FAN ONLY mode, the AUTOMATIC speed corresponds
to the high speed H.
AUTOMATIC
Set with the button the “AUTO” position
. The unit automatically controls the fan speed.
When the air conditioner starts operating, the fan speed
varies according to the thermal load of the room .
NOTE
MANUALE
If you want to manually adjust the fan speed just set the
button as desired:
SET
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE
AND THE WORD “SET”.
AFTER 5 SECONDS FROM THE
REQUIRED TEMPERATURE
SETTING THE DISPLAY
WILL SHOW THE ROOM
TEMPERATURE AGAIN.
AUTO
AUTO
AUTO
LM LM
MHHVH
MH Medium-high
H High
VH Very high
L Low
ML Medium-low
M Medium

Argo CLIMIA CMK 4000 WiFi Specifications

General

Brand	Argo
Model	CLIMIA CMK 4000 WiFi
Category	Air Conditioner
Language	English