Argo Frontier 650 8x8 2021 - Page 22

14
To cycle through Volt reading and Clock, push the "Select"
button. If the Voltage Bar is not visible, press and hold the
"Select" bar for 3 seconds. Figure 2-5
Figure 2-5. Voltage Bar
Figure 2-6. Clock
Operator may program:
• time/clock (Figure 2-6)
• digital display brightness
• kilometers/miles
To enter program settings, hold both Select & Adjust buttons
simultaneously for 3 seconds.
Timedisplayashes.Use"Adjust"buttontochangenumerical
value and "Select" button to move to next digit. Once correct
time is set, push "Select" button to advance to Digital Display
brightness.LCDbrightnessashes.Setbetween1and5for
brightness level.
Cycle through brightness levels with "Adjust" button. When
desired brightness level is achieved, push "Select" button to
advancetoKilometer/Milessetting.Miles/Kilometersashes.
Use "Adjust" button to cycle between miles and kilometers.
When desired setting is met,"Select" button.