45
AFTER INITIAL
The intervals shown on the schedule are based on average operating conditions. Vehicles which are subjected to
severe use and wet or dusty conditions will require more frequent servicing. Use only Argo replacement parts to
ensure safe operation of the vehicle and to comply with the warranty coverage.
We strongly recommend that an Argo Dealer perform a complete check-over of your vehicle after the initial
20 hours of operation, then once each year. This will reduce maintenance costs over the life of your vehicle.
X
X
X
X
X
X
X
X X
X
X X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X X
X
X
X
X
X
X X
X
BEFORE
EACH
USE
EVERY
Check Fuel Level
CheckTireInation
Check Finger Throttle Operation
Check Handle Bar Travel
Check Engine/Intake Exhaust for Obstructions
Check that the drain plugs are in place
Check Engine Oil Level
Change Engine Oil And Filter
Check Transmission Oil Level
Change Transmission Oil
Check/Clean Replace Air Filter
Service Driver And Driven Clutch
Lubricate Drive Chains
Remove, Clean And Lube Drive Chains
Lubricate Outer Axle Bearings
Lubricate Inner Axle Bearings
Lubricate Idler Shaft Bearings
Remove, Clean & Lube Idler Chains
Clean Battery Terminals & Connections
Clean Battery
Clean, Adjust/Replace Spark Plugs
Check The Drive Belt
Check Nylon Sliders - Driven Clutch
Check Sliders - Chain Take Up System
Check & Adjust Idler Chains
Inspect Brake Pads
Inspect/Adjust Emergency/Parking Brake
Check Hydraulic Brake Fluid Level/Condition
Check Fuel Tank Connections/Line
Inspect Wiring Harness
Re-Torque Bearing Extension Bolts
Clean Out Spark Arrestor
SECTION 7
MAINTENANCE INFORMATION
2h 8h 20h 10h
25h 50h 100h 250h
7.6 MAINTENANCE SCHEDULE
To Next Page
Loading...
