16
SECTION 3
OPERATING INSTRUCTIONS
Figure 3-3. Ignition Switch.
4. Ensureredswitchisin"run"position.(Seegure3.4)
5. Apply left hand brake lever.
6. Apply choke (if applicable).
7. Push green"START" button.
Figure 3.4 Ignition Switch.
8. Release the button as soon as the engine starts
9. Allow the engine to come to an idle.
10. Release choke (if applicable).
11. Release the parking brake.
12. If the engine fails to start, refer to the troubleshooting chart
in Section 8 for corrective action.
Do not operate the starter continuously for more than 5
seconds or the starter may overheat. Wait 30 seconds
between each operation of the starter to let it cool and
the battery power to recover. Never attempt to restart
the engine until the engine completely stops. Always
remove key from switch when leaving vehicle unattended
or when vehicle is not in use.
3.5 PRIMING PROCEDURE (EFI Models Only)
If the vehicle has run out of fuel, follow the procedure below
to prime the fuel system to restart.
1. Turn the key switch to the "RUN" position for one minute.
Allow the fuel pump to cycle and prime the system. Turn
the key switch "OFF".
2. Perform the STARTING PROCEDURE to crank and start
engine.
3. If the engine fails to start, repeat steps 1 and 2. If the engine
does not start after two priming intervals, contact your
Kohler Engine Service Dealer for further assistance.
3.6 STOPPING THE ENGINE
Releasethengerthrottlecontrol.Lettheenginespeedreturn
to idle and slide red "kill" switch to "OFF" position. (See
gure3.5)
Turn ignition key switch to the “OFF” position. Always
remove key from ignition switch when leaving the vehicle
unattended.
Figure 3.5 Ignition Switch.
3.7 SELECTING AND CHANGING TRANSMISSION
GEARS
DO NOT CHANGE TRANSMISSION GEARS WHILE THE
VEHICLE IS MOVING. To change gears, bring the vehicle to
a complete stop, let the engine idle down completely, engage
hand brake and move the shift lever to the selected gear.
To Next Page
Loading...
