IP address: The system accepts IPv4 and IPv6 addresses as well.
Type: The range of IP filtering
• HTTP: the settings are applied to HTTP requests
• STREAM: the settings are applied to stream requests
• HTTP+STREAM: the settings are applied to both HTTP and stream requests
Netmask: The blocked/accepted netmask. The netmask has to be given in a standard netmask form
(e.g. 255.255.255.0) so the value of the bits has to be set as a decimal value.
After clicking the Add button, the new exception will appear in the BLOCKED/ACCEPTED
ADDRESSES table above the edit fields. The elements of the table can be removed by clicking the
check box of the row and then clicking the Remove button. The above settings (default policy,
exceptions) will not be applied until clicking the Save button.
Before clicking the Save button, make sure that all settings are configured correctly, an incorrect
setup can block the user from accessing the camera. In this case the Restart & Recovery Mode
may be applied.
To Next Page
Loading...
