Ariens Razor Push Service Guide

EN – 8
REPLACE DRIVE BELT
Remove Drive Belt
IMPORTANT: Retain hardware for reinstallation.
Models 911175, 911179, 911188, 911190, 911375, 911379
For Models 911177, 911189, advance to step 11.
1. Place unit in service position. See Service Position on
page 7.
2. Remove blade. Refer to Operator’s Manual for
instructions.
See Figure 4.
3. Remove blade adapter and wave washer from
crankshaft.
4. Remove hardware retaining outer belt guide and
remove belt guide.
5. Loosen jam nuts on wheel drive cable adjustment
barrel. See Figure 5.
6. Disconnect drive cable spring from belt guide. See
Figure 6.
7. Remove hardware retaining inner belt guides and
remove belt guides. See Figure 7.
Figure 4
Figure 5
Figure 6
Figure 7

Ariens Razor Push Specifications

General

Brand	Ariens
Model	Razor Push
Category	Lawn Mower
Language	English