Aries 2051101 - Installation Steps; Step 1: Locate Mounting Points; Step 2: Install Front Bracket; Step 3: Install Middle and Rear Brackets

ARIESAUTOMOTIVE.COM • NEED ASSISTANCE? • 800.798.0813 • 2051101-INS-RA • PAGE 2
Step 1
Starting on the driver-side, locate
the three mounting locations and the
front bracket for the driver side.
Step 2
Locate the front two threaded mounting
locations. Place the front bracket up to
the vehicle and secure it using two 8mm
hex bolts, two 8mm lock washers and
two 8mm flat washers.
Step 3
Repeat step 2 to install the middle and
rear brackets over the mounting hole
locations from step 1.
Step 4
Remove the flat washers, lock washers
and hex nuts from the running board.
Carefully place the running board
onto the mounting brackets.
Slide each hex bolt into the appropriate
slot on the mounting bracket.