Ariston 100 L - User Manual

Other manuals for Ariston 100 L

Questions and Answers:

S
Susan KnightAug 27, 2025
Why is my Ariston 100 L Water Heater not hot enough?
- J
  Jessica HenryAug 27, 2025
  If your Ariston Water Heater isn't providing sufficient water temperature, there might be several reasons: * The product might be off. In this case, switch ON the product or ensure proper installation. * The temperature might be set too low. Increase the temperature setting. * You might be using a large amount of hot water while the product is heating. Try increasing the temperature set point. * The heater might be functioning in “Voyage” mode. Switch the mode of functioning. * The HC/HP installer menu parameter P8 might be ON. Keep parameter P8 OFF.
A
Andrew LeeAug 25, 2025
What to do if my Ariston 100 L is leaking water from the pressure safety device?
- J
  Joshua JonesAug 26, 2025
  If you notice water leaking from the pressure safety device of your Ariston Water Heater, keep in mind that some dripping is normal during the heating phase. To minimize this, install an expansion vessel on the delivery system. However, if the leak continues even after heating, check the calibration of the device and the mains water pressure. Warning: Never obstruct the device’s discharge outlet!
C
Christine BairdAug 25, 2025
Why is the water from my Ariston 100 L cold?
- S
  Susan ThomasAug 25, 2025
  If your Ariston Water Heater delivers cold or insufficiently hot water, first, raise the water temperature setting. If the issue persists, check for error messages on the display and follow the instructions in the “Errors” table. Also, check the voltage on the power terminals and inspect the wires and connections for any damage. Ensure sufficient airflow to the evaporator by regularly cleaning the grilles and ducts. Verify that the unit is switched ON and check the mains power supply. Be aware that using a large quantity of water while the product is heating can also affect the temperature. Finally, check for sensor errors 210 and 230, even if they appear only occasionally.

Ariston 100 L Specifications

General

Power Source	Electric
Pressure Rating	8 bar
Capacity	100 L
Type	Storage Water Heater
Thermostat	Adjustable
Temperature Range	Up to 75°C
Insulation	Polyurethane Foam
Warranty	2 years
Dimensions	Varies by model (approx. 913mm x 450mm x 480mm)
Weight	Varies by model (approx. 27 kg)