Programming manual for RD6203 Page 17
Up to four Central Station receiver telephone numbers can be programmed. Up to eight individual account
numbers can be allocated to each one. The number of account numbers that need to be programmed
depends on the number of areas configured and on how many report to Central Station.
SINGLE
AREA
SPLIT SYSTEM
Account
No. 1
Account
No. 2
Account
No. 3
Account
No. 4
Account
No. 5
Account
No. 6
Account
No. 7
Account
No. 8
CD 34
CD 61/62
Area 1 Not available
CD 72
Area 1 Area 2 Not available
CD91/92
Area 1 Area 2 Area 3 Area 4 Not available
CD95/150
Area 1 Area 2 Area 3 Area 4 Area 5 Area 6 Area 7 Area 8
Table 2. Allocating account numbers
i.e., For a single area alarm system programme Account No. 1. For a two area alarm system programme
Account No’s 1 and 2. etc.
Programming the Central Station account number:
1. From the “Tel/Account Nbrs” display, press the accept key ü.
Tel/Account Nbrs
Select the central station you want to programme by using the ↓
and ↑ keys. In this example, Central Station 1 is used.
ü
üü
ü + â
ââ
â or á
áá
á
Centr. Station 1
2. Press ü to accept the Central Station number displayed.
ü
üü
ü
The Central Station No.1 telephone number is displayed.
CS1 Teleph. Nbr.
3. Press the accept key ü. A blank screen with a flashing cursor
appears.
ü
üü
ü
4. Enter the Central Station No. 1 telephone number. The ↓ and ↑
keys control the cursor.
tel. number
To correct a digit, overwrite it with another digit, or delete the
whole number (see Table 1, “Programming telephone & account
numbers”) and start again.
5. When the number is correct, press the accept key ü.
ü
üü
ü
6. Use the down arrow key ↓ to move to the account numbers
display.
â
ââ
â
CS1 Account Nbrs.
7. Press the accept key ü.
ü
üü
ü
The Account number will be displayed.
CS1 Acc. Nbr. 1
8. Press the accept key ü and use the same method used to
programme the Central Station telephone number.
To Next Page
Loading...
General