Aritech Advisor RD 6203 - Protocol and Audio Listen-in Options

Page 18 Programming manual for RD6203
The same programming procedure is used to programme all telephone numbers and account numbers. A list
of the menu numbers (Quick codes) is shown below:
Central
Station
Tel. No.
Account
No. 1
Account
No. 2
Account
No. 3
Account
No. 4
Account
No. 5
Account
No. 6
Account
No. 7
Account
No. 8
1
1.1.1 1.1.2.1 1.1.2.2 1.1.2.3 1.1.2.4 1.1.2.5 1.1.2.6 1.1.2.7 1.1.2.8
2
1.2.1 1.2.2.1 1.2.2.2 1.2.2.3 1.2.2.4 1.2.2.5 1.2.2.6 1.2.2.7 1.2.2.8
3
1.3.1 1.3.2.1 1.3.2.2 1.3.2.3 1.3.2.4 1.3.2.5 1.3.2.6 1.3.2.7 1.3.2.8
4
1.4.1 1.4.2.1 1.4.2.2 1.4.2.3 1.4.2.4 1.4.2.5 1.4.2.6 1.4.2.7 1.4.2.8
Table 3. Quick codes for programming telephone & account numbers
There are two further options available: Protocol and Audio Listen-in.
Protocol
Protocol CS1
There are six protocols available. If required, each Central Station may have a different protocol.
Option Protocol
SIA 1
SIA1 protocol
Fast Format
Scancom Fast Format/Aritech Fast Format protocol
Contact ID
Ademco Contact ID protocol
Voice
Voice based message protocol (requires RD5060 voice module)
Semadigit
Pager based protocol
X SIA
SIA3 protocol supporting ALI and zone text transmission
Table 4. Overview of the possible protocols
Central
station
PROTOCOL
SIA Fast format Contact ID Voice Semadigit X SIA
1
1.1.3.1 1.1.3.2 1.1.3.3 1.1.3.4 1.1.3.5 1.1.3.6
2
1.2.3.1 1.2.3.2 1.2.3.3 1.2.3.4 1.2.3.5 1.2.3.6
3
1.3.3.1 1.3.3.2 1.3.3.3 1.3.3.4 1.3.3.5 1.3.3.6
4
1.4.3.1 1.4.3.2 1.4.3.3 1.4.3.4 1.4.3.5 1.4.3.6
Table 5. Quick codes of protocol options
Audio Listen-in (ALI)
ALI No
This is the option used in conjunction with XSIA protocol and add-on modules RD31xx/RD32xx series.
For all other protocols this should be set to “NO.”
The voice module option is not available when using the audio listen-in hardware.
Note: All central station ALI entries must be set to ‘NO’ for the voice module to operate correctly.