Chapter 5: Operate the Telephony Gateway
Light patterns that may appear on the status LED
Status LED Behavior
Off Powered off
Solid green Powering on
Flashing green (1/second) Booting up
Solid white Online and functioning
Solid red No Internet connectivity
Flashing blue WPS mode (times out after two minutes)
Flashing green (5/second) Factory reset in process
Wiring problems
If the Telephony Gateway begins flashing its LED for more than 10 seconds, this indicates a
problem with the telephone wiring — the red and green wires may be shorted (touching),
or there may be undesired voltage on the lines. If this pattern persists for more than 10
seconds, disconnect the telephone lines from the Telephony Gateway, then call a wiring
technician for assistance.
Touchstone TG4482 Telephony Gateway User Guide DRAFT Revision 1.3 27
To Next Page