10
any clipping. The metering is located in the signal chain just after
the preamp circuitry to help in setting signal levels going to your
computer. The monitor controls come after the metering so that
you can use the meters to set the overall input gain on each
channel for best recording dynamic range and then trim the Mon-
itor Mix and Level to the monitor system you are driving. The red
“Clip indicator” ring displays a red color just before clipping (2dB
before digital clipping and 6dB before analog clipping) and
should light on musical peaks only. The green “signal indicator”
comes on around 10dB before the “Clip indicator” and indicates
how far below clipping your signal is. The “signal indicator ring”
has a longer release time and should be on much of the time
during performance and if not, it indicates that your signal or in-
put gain may be too low for best results.
To Next Page
Loading...
