Cleaning and Disinfecting
NanoScope Manual
DFU-0298-1, Revision 0 Page 26 of 38
5.0 Cleaning and Disinfecting
5.1 NanoScope Console
The NanoScope Console is provided non-sterile and should not be
sterilized. The NanoScope Console can be cleaned/disinfected using a
clean cloth dampened with commercially available surfactants or
surface disinfectants only. The Console must not be submersed in any liquid.
Always allow adequate time for flammable solvent used for cleaning and
disinfecting to evaporate before using.
Always turn the power off and disconnect the external power adapter before
cleaning the Console.
Always comply with the instructions issued by the manufacturer of
the cleaning disinfectant regarding concentration, exposure times,
temperature and material compatibility.
NEVER allow the Console receptacles to have any contact with liquids.
If there is dust or moisture on the receptacles, remove with dry
compressed air. ONLYa dry Handpiece connector should be plugged
into the Console.
Do NOT clean the device with abrasive cleaning or disinfectant
compounds, solvents, or other materials that could scratch or damage
the device.
To Next Page
Loading...
Need help?
General
