Arturia MICROFREAK - Page 90

Category Parameter Description Utility MCC
Browsing
Knob catch
[Jump, Hook,
Scaled]
Different methods to match the physical knob position with
the digital value it represents
x x
Click to load
[Off, On]
Sets whether scrolling through presets loads them
immediately or whether an additional click is needed to
load them
x x
Category Parameter Description Utility MCC
Master
tuning
Cent offset
[-50 … 50]
Deviation from global tuning in Cents x x
A
Reference
[427.4-
452.89Hz]
The western tuning standard sets "A" at 440 hz. This setting
(which is basically the same as changing Cent offset) retunes
A to another pitch.
x x
Category Parameter Description Utility MCC
Misc
Mem
protect
[Off/
Factory
only/ On]
"Off" enables you to overwrite all presets. If set to "Factory only"
you cannot overwrite factory presets. If "On" your presets are
also protected agains accidental overwrites.
x x
KBD
sensitivity
[10% …
100%]
Sets the response level of the keyboard for both Pressure and
Velocity
x x
Aftertouch
curve [Lin,
Log, Exp]
Sets the keyboard response curve for Aftertouch x x
Velocity
curve [Lin
Log, Exp]
Sets the keyboard response curve for Velocity x x
Factory
reset
[Cancel,
Yes]
Resets your MicroFreak to the original Factory settings, erases
changes you made in Utility and erases your presets
x x
User
preset
erase
[Cancel,
Yes]
Erases User presets only. Remember first to make a backup to
the MCC if you decide to erase your presets!
x x
85 Arturia - User Manual MicroFreak - MicroFreak Configuration