CV pitch format (1V/Oct, Hz/V, 1.2V/Oct) - Defines the voltage level the MicroFreak will output
at the CV out. 1v/Oct (Eurorack and others), Hz/V, or 1.2V/Oct (Buchla).
CV Gate format (S-Trig, V-Trig 5V, V-Trig 12V) - Defines the gate voltage level the MicroFreak
will output at the Gate out.
CV Press range Pressure range [1V … 10V] - Sets the pressure voltage range the MicroFreak
will output at the Pressure out.
CV 0V reference 0V reference [C-1 … G8] - refers to which note will output zero volt when
pitch format is set to 0V/Oct.
CV 1V reference - 1V reference [C-1 … G8] - refers to which note will output one volt when
pitch format is set to Hz/V.
Knob Catch - Because the knobs are 360-degree encoders, they don't necessarily reflect
their underlying settings. There are three choices for how they behave when sending MIDI.
• Jump means a knob sends the value of its physical position as soon as you move
it, regardless of its stored setting. If the stored setting is 12, the knob happens to
be at 3, and you move it to 4, the parameter will jump instantly from a value of
12 to a value of 4.
• Hook waits until you move a knob past its current setting to "catch" (hook) it
before sending anything.
• Scaled increases or decreases the actual setting regardless of the knob position.
So if the actual value is 12 and you move the knob from 3 to 4, the actual value
will go to 13. Scaled allows you to increment or decrement the knob value. The
drawback is if the knob is at a high or low extreme, you obviously cannot move
it further. In this case, you need to turn the knob, and the value will have to go
either negative or positive first. This is the default mode.
Click to load Preset [Off, On] - Sets whether scrolling through presets loads them
immediately or whether an additional click is needed to load them.
Master Tuning - Sets deviation from global tuning in Cents.
Memory protection [Off, Factory only, All] - "Off" enables you to overwrite all presets. If set to
"Factory only" you cannot overwrite factory presets. If "All" your presets are also protected
against accidental overwrites.
KBD sensitivity [10% … 100%] - Sets the response level of the keyboard for both Pressure and
Velocity.
Aftertouch Curve - Lets you adjust the keyboard aftertouch curve. There are three options
Lin (linear), Log (logarithmic) and Exp (exponential). Please refer to the next entry, velocity
curve for an explanation of what these terms mean.
Arturia - User Manual MicroFreak - MicroFreak Configuration 88
To Next Page
Loading...
