Aruba AP-60 - The Aruba AP Setup Process

Introduction
Chapter 1
6 Aruba AP-60/61 0510160-03
Installation Guide April 2008
Fold-Out Stand
This fold-out stand allows the Aruba AP-60/61 to be stood upright on a table or
shelf.
Kensington Security Slot
This slot is compatible with a Kensington MicroSaver Security Cable (not
included) which can be used to prevent the unauthorized removal of the Aruba
AP-60/61 from its installed location. To secure the Aruba AP-60/61, wrap a
security cable around an immovable object, insert the cable’s lock into the
Kensington Security Slot, and turn the key.
N
OTE: The serial number and model number are on the bottom of the unit.
The Aruba AP Setup Process
Setting up an Aruba AP typically consists of four stages:
WLAN Planning—The administrator determines how many Aruba APs will be
needed for their wireless network strategy and where they will be deployed. This
can be easily accomplished using Aruba’s automated RF Plan site-survey
software (available separately).
AP Provisioning—Provisioning provides each Aruba AP with initial settings that
allow it to locate the host Aruba Mobility Controller. Depending on the network
topology and services, AP provisioning can be performed manually for each AP or
plug-and-play for batches of APs.
AP provisioning is discussed in Appendix 2, “Provisioning Access Points.”
AP Deployment—Once provisioned, the AP can be physically installed at its
intended place of operation.
AP deployment is covered in Chapter 2, “AP Deployment”.
AP Configuration—The administrator defines the operational behavior for each
Aruba AP, such as RF characteristics and security features.
For AP configuration information, refer to the ArubaOS User Guide.
3
4