Aruba AP-60 - Aruba AP-60 Detachable Antennas

AP Deployment
Chapter 2
8 Aruba AP-60/61 0510160-03
Installation Guide April 2008
The Aruba AP-60/61 can be mounted on a wall or suspended from above (not
shown) using one of the optional mounting kits (dimensions vary) in the
following ways:
FIGURE 2-1 Aruba AP-60/61 Mounting Options
NOTE: For dimensions, see Appendix 4, “Product Specifications”. Allow 5
cm (2") additional space on the right-hand side for cables.
Measurements for the Aruba AP-60 depend on attached antennas,
which vary.
Aruba AP-60 Detachable Antennas
Before deploying the Aruba AP-60, attach the appropriate antennas (not
included). The antenna connections should be tightened by hand to avoid
overtightening.
The Aruba AP-60 has dual Reverse Polarity SMA (RP-SMA) antenna connectors
that accept a variety of high-gain detachable antennas. See Table 2 - 1 for the list
of FCC approved antennas tested for use with the Aruba AP-60.
Make sure that all external antennas and their associated wiring are located
entirely indoors. The Aruba AP-60 Access Points and their optional external
antennas are not suitable for outside use.
1 2
3