Regular maintenance, safety tests and calibration
1590 99 002_1 - 21. Februar 2011 75
11 Regular maintenance, safety checks and calibration
The laser does not contain any user-serviceable components.
WARNING
The laser is operated with line voltage. There is the risk of an electrical shock and damage
to the eye!
The operation, maintenance, test and calibration instructions given in this manually
be followed.
Only service engineers employed with or trained by Asclepion Laser Technologies GmbH
are authorized to service the device. This also applies to the prescribed annual safety tests,
calibration included.
CAUTION
A too high output power of the laser can
cause side effects such as reddening, possibly
blistering, incrustation, seldom scars!
The output power of the therapeutic laser must be checked by a service technician of
Asclepion Laser Technologies GmbH or a qualified service technician of the
within the technical safety check at least once a year, the device is to be calibrated, too
required. The results of the check are to be documented in the Medical Device Logbook.
11.1 Routine maintenance
The routine maintenance procedures described below can be performed by the personnel of the
clinic or hospital.
General
Inspection of the outer surfaces of the device
Check if all cables are intact and connected firmly.
Frequency: weekly
To be checked by: personnel of clinic or hospital
Check of the cooling system
Check if all ventilation grids of the cooling system are free.
Frequency: weekly
To be checked by: personnel of clinic or hospital
Check of the handpiece
Check if the handpiece is in perfect state.
Frequency: before each use
To be checked by: operator of the device
To Next Page
