Customer service
74 1590 99 002_1 - 21. February 2011
10 Customer service
WARNING
The laser is operated with line voltage. There is the risk of an electrical shock and damage
to the eye!
Never open the device and attempt to re
pair the device yourself if the laser does not work
properly.
Only specialists appropriately qualified and authorized are allowed to open the laser
device.
The laser does not contain any user-
serviceable components. Only service engineers
employed with or
trained by Asclepion Laser Technologies GmbH are authorized to
service the device. This also applies to the prescribed annual safety tests.
If you need assistance by the Technical Service, please contact us via the address or phone number
given below. When contacting your service partner of Asclepion Laser Technologies GmbH, always
keep the model and the serial number of the device at hand. These numbers are specified on the
type plate located at the rear panel of the laser device.
Asclepion Laser Technologies GmbH
Service
Brüsseler Str. 10
D - 07747 JENA
Germany
Tel.: +49 (0) 3641 / 7700 - 401
Fax.:+49 (0) 3641 / 7700 - 402
E-mail: service@asclepion.com
Please note that the manufacturer, installer and importer will not consider themselves responsible for
the effects of servicing on safety, reliability and performance of the device unless the following
requirements are met:
installation, extensions, readjustments, modifications or repairs have been performed by
authorized persons,
the electric installation conditions of the laser room meet the requirements of IEC 64, as
amended, and
the device has been used in accordance with the instructions given in this manual.
To Next Page
