Asclepion MeDioStar - Recommended Protection Distances for RF Equipment

Cleaning, disinfection and sterilization
1590 99 002_1 - 21. Februar 2011 73
Possible malfunctions
Malfunction Explanation / corrective action
No power supply
Verify that the power cable has been connected to a power outlet.
Is th ?
Verify that the Laser emergency Stop switch is released.
Check the line fuses of the domestic power supply system.
Function keys of
t
h
e
display do not r
e
a
c
t
(or only
sporadically)
Faulty calibration of the touchscreen
The calibration is to be performed by an authorized service engineer.
Therefore, inform your vendor or directly the Technical Service
of Asclepion
Laser Technologies GmbH (see chapter 10 Fehler! Verweisquelle konnte
n
i
c
h
t
gefunden werden.).
No laser emissi
o
n
with the foot sw
i
t
c
h
pressed
Verify that the connecting cable of the foot switch is properly connected.
The device is in STANDBY. Press the READY key to switch to the READY
mode.