TD 92477EN
15 June 2012 / Ver. G
User Manual
Ascom d62 DECT Handset
46
Change System
Select “Automatic” or a specific system. If the handset is set to “Automatic” it selects a
system according to the priority list, see Priority on page 47.
Subscribe IP-DECT System (Release 4.0 and higher)
A handset can subscribe to an IP-DECT system automatically if the following are fulfiled:
• The IP-DECT system is configured for Easy Registration, see the corresponding
Installation and Operation manual for the IP-DECT system.
• The handset’s IPEI is registered in the IP-DECT system, see the corresponding Installation
and Operation manual for the IP-DECT system.
• The handset is not subscribed to any systems.
• The handset software is 3.2.x or greater.
1 If needed, switch off the handset by pressing .
2 Switch on the handset by pressing .
3 Select language to be used or press "Cancel". If Cancel is pressed, the default
language (English) will be used.
4 The handset starts to search for IP-DECT systems and will subscribe to the system
when it is found.
Note: If no system is found within 2 minutes, the handset’s subscription menu is
displayed, see Subscribe Other System for more information.
Subscribe Other System
If a handset shall subscribe to other systems such as IP-DECT (release 3 or older), or DECT,
the system must be subscribed manually. If the handset shall subscribe additional system, it
must also be added manually.
To subscribe a new system, the “Park:” (Portable Access Right Key) and “Ac:”
(Authentication code) related to the system are needed. Contact the system administrator
for more information.
Note: The PARK code may not be needed if there is no alien DECT system within the
coverage area.
The IPDI code is a unique code which has been assigned to the handset, see also 12.1 Admin
Menu on page 71.
1 Enter the menu by pressing the “Menu” soft key.
2 Select in the menu.
3 Select "System".
4 Select "Subscribe".
5 Press "Next".
6 Enter System name (optional). If no system name is entered, the default name will be
used. That is System A, System B etc. depending on which system name that is free.
7 Press "Next".
8 Enter PARK code (max. 31 digits). The PARK code may not be needed if there is no
alien DECT system within the coverage area.
9 Enter AC code. The AC code length must be between 4 - 8 digits.
10 Press "Next".
To Next Page
Loading...
