ASEA AC25QTP-1

To Next Page

To Previous Page

AC25/30QTP-1 and -3 Operations Manual.... 9

BREAKERS DISTRIBUTING POWER TO AND FROM THE

CONVERTER, AND THEN REMOVING THE INPUT SERVICE.

 SERVICE SHOULD BE REFERRED TO PERSONNEL AUTHORIZED

BY THE FACTORY TO SERVICE THIS EQUIPMENT.

Main Page

Certification2
Warranty2
Using this Manual3
Table of Contents4
Safety Notices7
Introduction to the Ac25Qtp and Ac30Qtp10
TABLE of FIGURES Figure 1: BLOCK DIAGRAM10
INTRODUCTION to the AC25QTP and AC30QTP, Cont11
Specifications12
Electrical Specifications12
Input Service12
Output Service12
Table 1: Input Specifications12
Table 2: Output Specifications12
Table 3: Output Current, Rated Continuous RMS13
Control, Metering, and Status14
Physical Specifications14
Mechanical14
Environmental14
Table 4: Physical Dimensions14
Installation15
Mechanical Installation16
Table 5: Recommended Installation Clearances16
Figure 2: MECHANICAL OUTLINE18
Figure 3: MOUNTING HOLE PATTERN19
Electrical Installation20
Table 6: Input Service Over-Current Protection Specifications20
Input Power Connections22
Output Power Connections22
Figure 4: INPUT and OUTPUT CONNECTIONS23
Figure 5: MODULE POWER CABLE CONNECTION24
Figure 6: MODULE GROUND CABLE CONECTION24
Grounding25
Multi-Cabinet Connections26
Figure 7: CONTROL MODULE CIRCUIT BOARDS26
Seamless Transfer Connections27
Other Optional Connections28
Operation29
Power Turn-On Procedure29
Figure 8: FRONT PANEL CONTROLS29
Systems Not Equipped with the Seamless Transfer Option31
Systems Equipped with the Seamless Transfer Option32
Multi-Cabinet Operation34
Auto-Restart Feature35
Operation36
Turn-Off Procedure37
Systems Not Equipped with the Seamless Transfer Option37
Systems Equipped with the Seamless Transfer Option38
Remote Communications39
Rs-232C/Scpi40
Figure 9: RS-232C PINOUT40
RS-485/Modbus41
Figure 10: RS-485 CONNECTIONS41
Software Features42
General42
Load Management42
Load Management Operation44
Shore Cord Alarm, Single, Master, and Slave Converters44
Shore Cord Setup, Single, Master, or Slave Converters45
Voltage Droop, Single or Master Converters46
Automatic Transfer to Generator, Single or Master Converters (Seamless Transfer Installed)47
Quick Setup of Shore Cord Alarm, Single, Master, or Slave Converters48
Generator Frequency Analysis49
Converter Output Impedance Control49
Agc Control50
Kw-HOUR METER and MAXIMUM POWER LEVEL DISPLAY51
Converter Output Voltage Control52
Event Log53
Trouble-Shooting and Diagnostics55
Common Problems55
Failure and Warning Messages56
Info Display56
Status Words57
Gathering Data57
Software Tools57
Figure 11: STATUS WORD BIT DEFINITIONS58
Calibration59
Maintenance61
International Power Form Reference62

ASEA AC25QTP-1 - Page 9

Table of Contents

Related product manuals