What to do if my Asko HI1655G shows error code F00?
If your Asko Hob displays error code F00, it indicates that the control panel is dirty or has water on it. Clean the control panel to resolve this issue.
Why is my Asko HI1655G not working and the display is blank?
If your Asko Hob isn't working and the display is blank, this indicates there is no power supply. Check the fuses or the electric switch (if there is no plug) to ensure proper power supply.
What does error code F8 and F08 mean on my Asko Hob?
Error codes F8 and F08 on your Asko Hob indicate that the appliance has overheated. The appliance has been switched off because of over heating. Allow the hob to cool down before using it again, and then start again on a lower setting.
What does error code FAN mean on my Asko HI1655G Hob?
Error code FAN on your Asko Hob means that the air circulation is not good. Make sure the venting holes under the cooking plate are open.
What does error code F7 mean on my Asko Hob?
Error code F7 on your Asko Hob indicates that the ambient temperature is not good. To resolve this, switch off all heat sources near the cooking plate.
What to do if my Asko HI1655G shows error code F99?
If your Asko Hob displays error code F99, it means you have pressed two or more buttons at the same time. Avoid pressing multiple buttons simultaneously.
Why does a fuse blow as soon as my Asko HI1655G is switched on?
If a fuse blows as soon as your Asko Hob is switched on, it suggests that the hob has been wrongly connected. Check the electrical connections.
What does 'br' on my Asko Hob display mean?
When ‘br’ appears in the display of your Asko Hob and the touch controls are not working, it indicates that the bridge function is activated. Deactivate the bridge function.
Why does the display keep flashing when I switch on a cooking zone on my Asko Hob?
If the display keeps flashing when you switch on a cooking zone on your Asko Hob, the pan you are using is not suitable for induction cooking, or has a diameter of less than 12 cm. Use a suitable pan.
What to do if my Asko HI1655G shows error code FA?
If your Asko Hob displays error code FA, it indicates that the mains voltage is too low. Contact your energy supplier to address this issue.
General| Type | Induction |
|---|---|
| Number of Cooking Zones | 5 |
| Width | 60 cm |
| Power Boost | Yes |
| Control Type | Touch |
| Frame type | Frameless |
| Safety Features | Child Lock, Overheat Protection |
To Next Page
