ASL INTERCOM V2000 - ASL Transfer Tool for IP Configuration

V2000 – Installation Guide
U-0623-0291.docx – Issue: 04 complete, approved
Page 13 of 40
c. Ensure that the interface card is fully pushed, and secure the interface card in position using
1 x screw at the bottom of the mainframe.
Do not fit the top 3 x screws as they are used to secure the LSZDC Surveillance
Interface Card (or the Surveillance Blanking Plate).
d. If used, repeat the above procedure for the second V2000-STBY Interface Card.
8. Ensure that all unused standby interface card slots are covered with a Standby Blanking Plate.
Any blanking plates removed from the V2000 as part of the installation process ideally
should be recycled as metal or otherwise responsibly disposed of by following WEEE
protocols.
Fully push the interface card
and secure it using a screw at
the bottom of the mainframe.
M3 (4 mm) Pozi
countersunk
screw
Do not fit the top
3 x screws.
Second V2000-STBY
Interface Card slot
Fit a Standby Blanking Plate (ASL PN M0623_08)
to all unused standby interface card slots.
Secure the blanking plate using a screw at the
bottom of the mainframe.