ASM Polytouch HYDRASYNTH EXPLORER - Tremolo; Compressor

48
Tremolo
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p.
46)
Selects eect
1 2 [Rate] 0.02-10.0 Hz Controls tremolo rate
1 3 [Depth] 0.0-128.0 Controls chorus depth
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Preset 1-3 Selects template
2 2 LFO shape Sine, Square Selects tremolo waveshape
2 3 Phase +/- 180° Phase relationship of left/right LFOs
2 4 Pitch Mod 0-127 Vibrato depth
EQ
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p. 46) Selects eect
1 2 [HighGain] - 36.0 / + 24.0 dB High frequency cut/boost
1 3 [LowGain] - 36.0 / + 24.0 dB Low frequency cut/boost
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Preset Flat, LowBoost, Bass Cut, High Cut,
Smile, Lo-Fi, Warm
Selects template
2 2 MidGain - 36.0 / + 24.0 dB Mid frequency cut/boost
2 3 Xover Lo 32-2,000 Hz Sets low/mid crossover point
2 4 Xover Hi 512-16,000 Hz Sets mid/high crossover point
Compressor
Page Control Parameter Range Description
1 1 FX Type
9 types (see Pre- and Post-FX (p.
46)
Selects eect
1 2 [Ratio] 1.0 :1 to 20.0 :1 Sets compressor strength above
threshold
1 3 [Threshold] -64.0 to 0.0 dB Level at which compression begins
1 4 [Dry/Wet] 0-100.0% Sets dry signal/eect blend
2 1 Sidechain O, BPM Duck, Tap Source: Arp clock, Tap Tempo
2 2 Attack 1-400 ms Time to maximum compression
2 3 Release 5-560 ms Time to zero compression if signal is
below threshold
2 4 Output 0-512 Gain compensation