ASM Polytouch HYDRASYNTH EXPLORER - CV - Mods; Calibration; Calibrate Wheels; System

77
CV – Mods: Page 15
These settings enable the use of devices with dierent CV standards. For example, Output Mod 1 can be
set to +/- 5V while Output Mod 2 are set to 0-5V. The Oset ranges are independent, which allows the
voltages to be ne-tuned to compensate for the idiosyncrasies of individual devices.
Control Parameter Range
1 OM1 Range (Mod 1 output) +/- 5V, 0-5V, 0-1V
2 OM2 Range (Mod 2 output) +/- 5V, 0-5V, 0-1V
3 OM1 Oset (Mod 1 output) +/- 3.0V
4 OM2 Oset (Mod 2 output) +/- 3.0V
The allowable range for output voltages is from -5V to 5V. If an output value attempts to exceed
the range, it will be clipped automatically to the lowest or highest possible value depending on
which value has been exceeded.
Calibration: Page 16
Control Parameter Range Description
1 Calibrate Wheels (access) Full-range motion of the pitch and mod strips
Calibrate Wheels
Press Control button 1 to access the calibration page and follow the instructions on Left display. Move
each strip slowly through its entire range, then press [EXIT]
System: Page 17
Control Parameter Range Description
1 Self Test (action) Hold the button and all LEDs and displays are lit at maximum for
visual inspection.
2 Factory Reset (action) Resets all parameters in System Setup to their default values. This
does not erase the patch banks.
OS: Page 18
There are only two items on this page: the OS version and the embedded serial number. Please include
these in any communications you might have with our Technical Support department.
And always install the latest rmware in your Hydrasynth Explorer so you can take advantage of new
features as they are added!