Asmoke AS300 - Understanding the Control Board

UNDERSTANDING
THE CONTROL
BOARD
The
UCO Screenis used as the information center for
your
unit.
The
LCD screen will display the cunent
grill
temperature
(ACTUAL)
and
meat
probe
temperature
(MP1).
SeeTnubleshooting
for more information on enor codes.
lndicates the unit was
just
mnnected to
AC
power.
Screen flashes
three
times, $en
tums off.
lndicates
he meat
probe
temperaturc
lndicates he cunent temperature
of unit.
lndicates
the desired temperature
that has
been selected.
lndicated
that no meat
probe
is
Failure to reaci minimum temperature of
Fire has
oone
out due to lack
of fuel.
lndicates
the auger motor is tuming and
lndicates fte
igniter is on. When first
starting
your
unit, the igniter runs
brthe start-up cycle.
lndicates
the fan is running. lf the
grill
is
in
operalion,
the fan is on.
lndicates the
auger
mobr
h
no longer able
to feed
pellets
to the fire
pot.
Likely, the
hopper is empty and
requires
refilling.
Press and hold thePrime
Button to activate an extra
feed
of
pellets
to the
fire
pot.
This
can be
used to
add
more
fuel to
the fire
just
before
opening the banel lid, resulting in a
quicker
heat
recorery time. lt can also
be used to add morc
fuelwhile
smoking,
to
increase
the
intensity
of clean
smoke
fiavor.
Overfeeding
the fire
pot
may
damage
to
grill
barrel
paint.
The
Temperature Switch
Button is used to change
the
temperature
readout
on the LED Screen. Press the button
to
switch to
Fahrenheit
(oF)
or to Celsius
(oC),
as
prefened.
Default
is set to Fahrenheit.
12