2 80-0180-418, Rev D
IMPORTANT: This product must be installed according to all applicable building and
life safety codes!
Tools and Equipment Needed
The following common hand tools are needed for installation:
• 7/32” [5.56 mm], 1/4” [6.35 mm], and 3/8” [9.53 mm] drill bits
• 3/32” [2.38 mm] Allen Wrench
• Center punch
• Drill
• Flat tip screwdriver
• Phillips screwdriver
• Pencil
Preparing the Stile
NOTE: Figure 1, “Rivnut Installation for 31/32” [24.61 mm] and 1-1/8” [28.58 mm] Backset,
Single Lever,” and Figure 2, “Rivnut Installation for 1-1/2” [38.1 mm] Backset, Single
Lever,” provide illustration for the following steps.
1. IF using a 1-1/8” [28.58 mm] backset,
THEN MARK a vertical reference line 5/32” [3.97 mm] behind the backset centerline.
2. APPLY the stick-on template over the cylinder backset centerline reference 5/32” [3.97 mm]
offset to clear the stop on the frame for a 1-1/8” [28.58 mm] backset.
3. CENTERPUNCH all holes.
4. DRILL holes at center punch locations.
5. REMOVE the template.
To Next Page
Loading...
Need help?
General
