4 80-0180-418, Rev D
Offsetting the Escutcheon for 31/32” [24.61 mm] and
1-1/8” [28.58 mm] Backset
1. LOOSEN the two #4-40 x 1/4” flat head screws securing the adjustable cover on the back of
the trim cartridge until the cover can be slid (see Figure 3, “Adjustable Cover and Trim
Cartridge”).
2. PUSH the adjustable cover toward the nose edge of the door until it stops (see Figure 3).
3. TIGHTEN the two #4-40 flat head screws to secure the adjustable cover in place.
Figure 3. Adjustable Cover and Trim Cartridge
Optional Monitoring Switch
NOTE 1: Monitored trim contains an internally mounted switch (see Figure 4, “Optional Monitor
Switch”), secured with two M1.6 x .35 mm Phillips pan head screws. The switch is
activated when the handle is rotated to the UNLOCK position.
NOTE 2: All unused leads from the monitor switch must be terminated.
Figure 4. Optional Monitor Switch
To Next Page
Loading...
Need help?
General
