6
Removing or Replacing the End Caps
NOTE: To
facilitate maintenance procedures, the two end caps can be
removed.
1. PERFORM the following to remove the end caps.
a. INSERT a small Phillips tip screwdriver through the holes located in
the end caps and UNSCREW the concealed attachment screws.
b. REMOVE the end caps and SET aside.
2. PERFORM the following to replace the end caps.
a. LOCATE the end caps on the push bar.
NOTE: When replacing the end caps, the screws must be snapped in
the screw clips on the inside of the end caps.
b. ATTACH the end caps using a small Phillips tip screwdriver through
the holes located in the end caps and TIGHTEN the attachment
screws hand tight only.
To Next Page
Loading...
