Why does the Assa Abloy SW200 Door Opening System open and close continuously?
If an automatic activation unit is installed, ensure there are no moving objects within 39"-59" (1-1.5 m) of the door. The continuous opening and closing might be triggered by such movement.
What to do if the Assa Abloy SW200 Door Opening System motor starts but the door doesn't open?
First, ensure that all mechanical locks are unlocked. Second, check underneath the door to confirm that nothing is obstructing its movement.
How to fix an Assa Abloy SW200 when the motor does not start?
Here are a few things you can check: 1. Adjust the setting of the program selector. 2. If a sensor is installed, make sure there are no objects within its detection zone. 3. Verify that the mains switch is on and the fuse in the building is intact.
General| Protection Rating | IP20 |
|---|---|
| Power Supply | 230 VAC, 50/60 Hz |
| Operating Temperature | -20°C to +50°C |
| Control | Microprocessor control |
| Safety | Obstacle detection |
| Compliance | EN 16005 |
| Ambient Temperature | -15°C to +50°C |
| Relative Humidity | Up to 95% non-condensing |
| Opening Speed | Adjustable |
| Closing Speed | Adjustable |
| Hold-open Time | Adjustable, 0-30 seconds |
| Dimensions | 100 mm |
Specific daily checks for motion and presence sensors.
Specific daily checks for floor mat activation and safety.
Checks for structural integrity of guide rails and door stile looseness.
Maintaining a clear and safe area around the door.
Advice on managing pedestrian flow for safe entry/exit.
Inspection of the finger guard for security and condition.
Specific signage for caution on both sides of the door.
Recommended signage for accessibility features.
Signage indicating how to activate the door via switches.
Signage for manual activation methods like push or pull.
Recommended signage for disabled activation methods.
Signage indicating no entry or one-way traffic direction.
Signage for caution and one-way traffic.
Signage for the front side of the automatic door.
To Next Page
