Why does the Assa Abloy SW200 Door Opening System open and close continuously?
If an automatic activation unit is installed, ensure there are no moving objects within 39"-59" (1-1.5 m) of the door. The continuous opening and closing might be triggered by such movement.
What to do if the Assa Abloy SW200 Door Opening System motor starts but the door doesn't open?
First, ensure that all mechanical locks are unlocked. Second, check underneath the door to confirm that nothing is obstructing its movement.
How to fix an Assa Abloy SW200 when the motor does not start?
Here are a few things you can check: 1. Adjust the setting of the program selector. 2. If a sensor is installed, make sure there are no objects within its detection zone. 3. Verify that the mains switch is on and the fuse in the building is intact.
General| Protection Rating | IP20 |
|---|---|
| Power Supply | 230 VAC, 50/60 Hz |
| Operating Temperature | -20°C to +50°C |
| Control | Microprocessor control |
| Safety | Obstacle detection |
| Compliance | EN 16005 |
| Ambient Temperature | -15°C to +50°C |
| Relative Humidity | Up to 95% non-condensing |
| Opening Speed | Adjustable |
| Closing Speed | Adjustable |
| Hold-open Time | Adjustable, 0-30 seconds |
| Dimensions | 100 mm |
To Next Page
